Anonymousprnt::Y
Find:

   |


 
 
Click on images to see them in full screen

Introduction

Door Tablet offers Health and Motion Sensors. These sensors are installed inside meeting spaces and communicate with the tablets outside of them. The main purpose of the sensors is to:
  1. Provide Internal Air Quality and CO2 monitoring and alerts (Health Sensors)
  2. Show space status on both single and wayfinding displays (Motion Sensor)
  3. Automatically check-in to meetings (Motion Sensor)
  4. Terminate meetings in unoccupied meeting spaces (Motion Sensor)
VIDEO: Sensor and LED controller

The Door Tablet sensors are easy to configure and install. The following steps are required:

  1. Prepare your sensors or relay by first attaching the Device Hub to your PC using a USB cable
  2. Install the Device Hub and provide it with power and network connection
  3. Configure sensors and note connection information
  4. Install the sensors in the ceiling or walls of meeting spaces and communal areas
  5. Test connection to the Device Hub from Door Tablet end-points outside the meeting spaces, or on wayfinders
  6. Configure Door Tablet Admin UI to indicate that sensors or controls are used, and how you wish the system to react to motion and alert on Air quality/CO2
  7. If you are using a relay to control a door, you will need to set that up to


Once you inserted a device hub IP to a room record you must Distribute your licences again.


Sensors connected to network electronics in a protective case.



CO2 sensor


Climate sensor



Relays
Door Tablet can open doors without the need to use Access Control. Door operation are triggered in a number of use case, such as check-in, admin open, reservation and so on. The image below show a relay that connects to the Device Hub, and acts as a switch to a maglock.



Crestron Sensors

From V10.0.10 onwards, Door Tablet integrates with Crestron Occupancy sensors connected using PoE

Sensor Configuration Types

The Door Tablet sensors come in four forms. In all cases the sensors are connected to your internal ethernet network.
  1. PoE powered and networked
  2. Ethernet with local, in ceiling, USB power source
  3. Wi-Fi with local, in ceiling, USB power source
  4. USB only connection for Windows based end-point devices such as Door Tablet WM, Door Tablet MM and Intel UNITE hub. See here Database 'Door Tablet HELP', View 'Help Documents', Document 'USB only setup'

Note: The Crestron motion sensor connects to Crestron displays only. Read more here Database 'Door Tablet HELP', View 'Help Documents', Document 'Crestron Displays'

How Door Tablet connects to sensors
Our sensors, monitors or relay connect using IP protocols and are connected directly on your network. They appear as hosts on your LAN and do not require a room controller. When placing devices on your network you assign them a fixed IP address from your internal pool. Your network administrator should provide you with a range of IP addresses you should use when configuring sensors. You then assign a sensor or relay per room using the Door Tablet Web UI. The Door Tablet Apps will communicate with the device hub. The Door Tablet server does not participate in the dialogue between Door Tablet and Device Hubs. The data stored in the Door Tablet configuration database is used by the Apps to determine which device to connect to and what to do with sensing or control events. To make testing and deployment easier, device hub addresses may be overwritten on the tablet App, while the behaviour is always governed by the Door Tablet server data.

For information on sensors hardware click here Database 'Door Tablet HELP', View 'Help Documents', Document 'Sensor Hardware'


Licensing

You are required to perform licensing action relating to sensors. If you wish to use Sensors with Door Tablet these must be purchased from us and tested by us before you can deploy these.